click here to chat with us

NRG10-115AC-4Q DC Motor Control


The NRG10-115AC-4Q, with a robust set of features, is easy to use and at the same time, will satisfy demanding application requirements. In addition to on-board fusing to protect your motor and drive, the it will accept any AC input voltage bewteen 90 and 120VAC at 50 or 60Hz. With the auto-ranging power supply there are no switches to set, no settings to change.

This highly efficient, near unity form factor PWM regenerative drive will increase motor performance while reducing your energy costs. MOSFET power in PWM drives switch at 16kHz, to provide fast circuit response and the constant 1.05 (pure DC is 1.00) form factor throughout the entire 100:1 speed range.

The NRG10-115AC-4Q will work with isolated logic signals, motion controllers and programmable logic controllers. It is also compatible with Minarik Drives' popular PCM4 signal isolator and DLC600 digital controller.

Potentiometer Kit 202-0003 is included with a purchase of the NRG10-115AC-4Q

Let's Talk About Your Project


Contact the factory for volume pricing

Enclosure Maximum
Power Range Field / Shunt
Reversing Isolation
NRG10-115AC-4Q Chassis 10 115 0 - 130 1/4 - 1 .20 - .75 No Yes No
  • 4Q Reversing: Regenerative/4 Quadrant drives have the ability to perform quick, contactorless reversing on-the-fly!
  • Speed range and regulation: 1% regulation over 100:1 speed range. 0.1% regulation over 100:1 speed range with the addition of a tachometer for feedback. Armature or tachometer mode is switch selectable.
  • User adjustable calibration pots: IR compensation, motor torque, regen torque, tachometer, min speed offset, forward max speed, reverse max speed, forward acceleration, reverse acceleration and inhibit offset.
  • Diagnostic LEDs: LEDs for motoring, regen (torque or braking), current limit and over-voltage coast.
  • Stopping Modes: User can decelerate (N.O.), regeneratively brake (N.O.) or coast to a stop (N.C.).
  • Cage clamp terminal block: Quick and easy wire terminations.
  • Inhibit personality switch: Choose whether you brake or coast to a stop. Use inhibit plug (201-0024).
  • Auto-ranging power supply: Can accept a 90-240VAC or 80-340VDC as an alternative to an AC input. Connections will vary.