click here to chat with us
EZQUADHRSTEPPER

EZQUADHRSTEPPER Stepper Control from AllMotion

Stepper Motor Controllers

AllMotion, a brand of American Control Electronics, designs and manufactures miniature high-performance stepper and servo drives.

The EZQuad HR Stepper was designed to allow the rapid implementation of multi axis stepper motor solutions in products requiring automation and encoder feedback.

Measuring only 2.25" x 2.25" X 1.0" (57mm x 57mm X 25mm), the fully intelligent stepper motor Controller + Drivers runs 4 fully independent stepper motors (see wiring diagram). Operating from a 10V to 40V supply the controller regulates to any motor voltage via software command. (Eg 6V motor can be run with 24V supply). Commands can be issued from any serial terminal program (such as HyperTerminal) or from the EZStepper Windows application.

The EZQuad HR Stepper will drive 4 motors at 1 Amps each with a setting of move current m=50 %. However with careful selection of motors and/or improved cooling and/or low move time duty cycle it is possible to run motors at 2 Amps at m=100%. See Command Set for details.

The Commands are intuitive and simple. For example, the command A10000 will move the stepper motor to Absolute position 10000. (This communications protocol is compatible with devices that use the Cavro DT or OEM protocol.)

The EZQuad HR Stepper is also capable of stand-alone operation with no connection to a PC. It can be set to execute a preset string of commands upon power up (i.e., only power is required in this mode). The Commands include nested loops and execution halt pending a switch closure, which is useful in stand-alone applications.

The EZQuad HR Stepper Motor Controller will typically work with any motor that is 3" or smaller (size 23 or smaller). Our Starter Kits enable a first time user to make Stepper Motors move intelligently in less than half an hour.


Click here to be redirected to AllMotion.com to purchase the EZQUADHRSTEPPER

Let's Talk About Your Project

$527.00

Contact the factory for volume pricing

Model
Number
Type Voltage
(VDC)
Current
(ADC)
Step Resolution # of
Axis
Feedback Communication

EZQUADHRSTEPPER
 
Controller + Driver 12 - 40 5 1, 1/21/41/81/161/321/641/1281/256 4 Encoder RS485
USB
CAN bus
RS232*

* RS232 interface available when used with a RS485 Converter.

Features

  • Full featured 4 Axis position controller with power drivers
  • Fully programmable ramps and speeds
  • Four independent 2 Amp 256 Micro Stepping Drives
  • 6 Quadrature Encoder Inputs
  • Operates from 10V to 40V
  • RS232, RS485, USB or CAN BUS based Communications
  • Direct USB, 485 and CAN BUS connection built in
  • On Board EEPROM For User Program storage
  • Stand alone operation with no connection to a PC
  • Execution Halt/Branch pending switch closure
  • Pre-wired for OptoSwitch inputs (see wiring diagram)
  • Industry standard communications protocol
  • Homes to an Opto or Switch closure with a single command
  • 16 Digital In and 16 Power On/Off Drivers included
  • Switch selectable device address
  • Independent Parameters for all Axes (Acceleration, Velocity, Currents etc)
  • Daisy-Chainable with other Allmotion Products on a Single 4 wire bus