Competitor Search
click here to chat with us
Picture of MC10-R DC Motor Control

MC10-R DC Motor Control

MC10 Series

The MC10-R accepts 115 or 230VAC input for operation of 90 and 180VDC permanent magnet or shunt wound DC motors (50/100/200VDC field voltage) from 1/8 to 2 horsepower.

Included are power and current limit LEDs, line fuses, inhibit pins for remote start/stop and mounted on the front cover are a speed potentiometer and On/Off switch.

Setup is easy with trimmer pot adjustments for minimum speed, maximum speed, acceleration, deceleration, IR compensation and current limit and a screw terminal block for easy wire connections.

Please login to view pricing.

Contact the factory for volume pricing

Enclosure Maximum
Power Range Field / Shunt
Braking Reversing Isolation
MC10-R NEMA 4X 10 115 0 - 90 1/8 - 1 .09 - .75 50 / 100 No Yes
230 0 - 90 1/8 - 1 .09 - .75 100 / 200
0 - 180 1/4 - 2 .19 - 1.5


  • NEMA 4X Plastic Enclosure: Plastic corrosion resistant weatherproof enclosure that protects against dirt and splashing
  • Field Supply: Voltage output to energize the field winding of a shunt-wound motor
  • Stopping Modes: Inhibit (N.O) for coasting to a stop. Can be used for frequent starting and stopping
  • Diagnostic LEDs: Current Limit, Power
  • Reversing: Reversing switch swaps armature leads to change motor direction. Motor must be stopped before changing direction
  • Pre-Wired Switches: FORWARD/OFF/REVERSE

Technical Data

  • 1.37 Form Factor
  • 1% Base Speed Regulation
  • 60:1 Speed Range

Trim Pots

  • Maximum Speed
  • Minimum Speed
  • Acceleration
  • Deceleration
  • Current Limit
  • IR Compensation
Introduction to the MC10 Series
MC10 Series Wiring
MC10-R Reversing Operation