UPVFD02-D230AC

UPVFD02-D230AC

Series:

Part Number: UPVFD02-D230AC

The UPVFD series is a microprocessor based variable frequency drive. These drives look and act like DC drives, meaning quick and easy setup without any programming. -115AC models allow 115 VAC in and 115 VAC out. –D230AC models allow 230 VAC in and 230 VAC out, but are also equipped with a unique voltage doubling capability that allows you to run a 230 VAC motor when only 115 VAC single phase power is available. 

While the input is single phase, the output can be single or three phase for all UPVFD series drives. The drive’s internal carrier frequency can easily be changed from 16 kHz to 1.6kHz to minimize switching losses or reduce electrical interference. 

Stopping methods include coast to stop or DC injection braking. Incorporated into the design is a microprocessor which provides flexibility of the creating custom programs that can include specific user settings for OEM applications. These full featured and compact AC drives are the perfect choice to run any 3 phase, and now some single-phase motors rated at 4 amps or below. 

$246.18
Model
Number
Enclosure Maximum
Current
(AAC)
Input Output Power Range Reversing Isolation
Voltage
(VAC)
Freq.
(Hz)
Phase Voltage
(VAC)
Freq.
(Hz)
Phase HP kW
UPVFD02-D230AC Chassis 2.4 115 or 230 50 / 60 0 - 115 50 / 60 1Φ / 3Φ 1/16 - 1/4 .05 - .20 Yes No
 0 - 230 1/8 - 1/2   .10 - .37
  • Compact size: Same bolt pattern as MM footprint industry standard mounting hole pattern.
  • “D” models can double the output voltage: Enables the use of a 230 VAC single or three phase motor with a 115 VAC single-phase supply. Do not use 115 VAC motors on “D” models.
  • Microprocessor based: Allows custom programing for OEMs.
  • Use with a variety of motors: Can be used with 3-phase induction and single-phase permanent split capacitor (PSC), shaded pole and synchronous motors.
  • Diagnostic LED: LED for power and status (undervoltage, overvoltage, short circuit/current trip, heating warning/trip).
  • Thermally protects: Drive recognizes when overheated as a result of overload. It first flashes a warning code on the status LED and will eventually trip if the condition persists.
  • Stopping modes: DC injection braking or coast to stop.
  • User adjustable calibration pots: Minimum Speed, Maximum Speed, Current Limit, Slip Compensation, Boost, Acceleration and Deceleration/DC Brake Injection.
  • RoHS: All VFD series models are RoHS compliant 
Introduction to the UPVFD Series
UPVFD Series Wiring
UPVFD Series Dip Switch Configurations
UPVFD Series Slip Compensation Calibration
UPVFD Series Boost Trim-pot