Series: MC10 Series

Part Number: MC10

Patriot drives MC10 accepts 115 or 230VAC input for operation of 90 and 180VDC permanent magnet or shunt wound DC motors (50/100/200VDC field voltage) from 1/8 to 2 horsepower.

Included are power and current limit LEDs, line fuses, inhibit pins for remote start/stop and mounted on the front cover are a speed potentiometer and On/Off switch.

Setup is easy with trimmer pot adjustments for minimum speed, maximum speed, acceleration, deceleration, IR compensation and current limit and a screw terminal block for easy wire connections.
Enclosure Maximum
Power Range Field / Shunt
Reversing Isolation
MC10 NEMA 4X 10 115 0 - 90 1/8 - 1 .10 - .75 50 / 100 No No
230 0 - 90 1/8 - 1 .10 - .75 100 / 200
0 - 180 1/4 - 2 .20 - 1.5
  • NEMA 4X enclosure:Plastic enclosure protects against outer corrosive material and incidental contact.
  • Dual voltage AC input: Accepts either 115VAC or 230VAC power input.
  • 1% speed regulation over 60:1 speed range: Excellent open loop speed control over a wide range.
  • Inhibit circuitry and terminal: Convenient remote start/stop control.
  • User adjustable calibration pots: IR compensation, minimum speed, maximum speed, acceleration, deceleration and IR compensation.
  • Diagnostic LEDs: LEDs for power and current limit status.
  • Clean easy to use design:Power, direction and speed adjust knob located on front cover for easy operation.
  • Screw terminal block for power wiring:Secure and strong power connections.
  • Field voltage supply for shunt wound motors:50/100VDC with 115VAC input or 100/200VDC with 230VAC input, 1A maximum.
  • Commercial Machinery
  • Pumps
  • Printers
  • Industrial Machinery
  • Packaging Machinery
  • Conveyors
Introduction to the MC10 Series
MC10 Series Wiring