MM23201C DC Motor Control

MM23000C Series

Minarik Drives' MM23201C is housed within an aluminum NEMA 1 enclosure guaranteeing protection from hands, falling dirt or any other unwanted external solid objects that present a hazard. Users make all wire terminations at the screw terminal strip inside the enclosure and operate the drive through the pre-mounted speed potentiometer, power switch, and brake or reversing switch when applicable.

The MM23000C Series of drives are a reliable and cost-effective solution for controlling your permanent magnet or shunt-wound DC motors in variable speed applications. The MM23000C Series uses SCRs to provide full-wave rectification of the AC line input.

The MM23201C drive is a dual voltage drive that has the can operate in 115 VAC or 230 VAC, 50/60 Hz, to run 90 or 180 VDC SCR brush-type motors. This drive controls motors from 1/8 to 2 HP.

Let's Talk About Your Project

$429.44

Qty:

Contact the factory for volume pricing

Model Number	Enclosure	Maximum Current (ADC)	Input Voltage (VAC)	Output Voltage (VDC)	Power Range		Field / Shunt Supply	Braking	Reversing	Isolation
					HP	kW
MM23201C	NEMA 1	10*	115	0 - 90	1/8 - 1	.09 - .75	50 / 100	Yes (Dynamic Braking Resistor)	Yes (Armature Switching)	No
			230	0 - 90	1/8 - 1	.09 - .75	100 / 200
				0 - 180	1/4 - 2	.19 - 1.5

* Heat sink kit 223-0174 must be used when the continuous output current is above 5 amps.

Features

NEMA 1 Enclosure: Prevents accidental contact with the circuit board
Field Supply: Voltage output to energize the field winding of a shunt-wound motor
Diagnostic LEDs: Current Limit
Case LEDs: Power
Dynamic Brake Resistor: Braking the motor to zero speed quicker than coasting
Reversing: Reversing switch swaps armature leads to change motor direction. Motor must be
stopped before changing direction
Pre-Wired Switches: ON/OFF, RUN/BRAKE, FORWARD/REVERSE