MC10 DC Motor Control

MC10 Series

The MC10 accepts 115 or 230VAC input for operation of 90 and 180VDC permanent magnet or shunt wound DC motors (50/100/200VDC field voltage) from 1/8 to 2 horsepower.

Included are power and current limit LEDs, line fuses, inhibit pins for remote start/stop and mounted on the front cover are a speed potentiometer and On/Off switch.

Setup is easy with trimmer pot adjustments for minimum speed, maximum speed, acceleration, deceleration, IR compensation and current limit and a screw terminal block for easy wire connections.

$437.62

Qty:

Contact the factory for volume pricing

Model Number	Enclosure	Maximum Current (ADC)	Input Voltage (VAC)	Output Voltage (VDC)	Power Range		Field / Shunt Supply	Braking	Reversing	Isolation
					HP	kW
MC10	NEMA 4X	10	115	0 - 90	1/8 - 1	.09 - .75	50 / 100	No	No	No
			230	0 - 90	1/8 - 1	.09 - .75	100 / 200
				0 - 180	1/4 - 2	.19 - 1.5

Features

NEMA 4X Plastic Enclosure: Plastic corrosion resistant weatherproof enclosure that protects against dirt and splashing
Field Supply: Voltage output to energize the field winding of a shunt-wound motor
Stopping Modes: Inhibit (N.O) for coasting to a stop. Can be used for frequent starting and stopping
Diagnostic LEDs: Current Limit, Power
Pre-Wired Switches: ON/OFF

Technical Data

1.37 Form Factor
1% Base Speed Regulation
60:1 Speed Range

Trim Pots

Maximum Speed
Minimum Speed
Acceleration
Deceleration
Current Limit
IR Compensation

Introduction to the MC10 Series

MC10 Series Wiring