click here to chat with us

PCMXP10-115AC DC Motor Control

XP Series

Minarik Drives expanded the XP series of low-cost, high-performance, pulse-width-modulation (PWM) DC drives to offer the PCMXP10-115AC, which accepts any external analog process control signal from 0 to 10VDC. Users can operate the drive in two distinct modes: manual mode using normal potentiometer operation or signal mode: operation from an external signal input only.

Standard XP drives are versatile and accept any voltage ranging from 70 to 130VAC. XP drives contain a unipolar power supply, which enables them to accept any DC volage input between 100 and 160VDC. Users, after proper calibration, can operate many low voltage motors without additional circuitry. The PCMXP10-115AC yields a constant 1.05 form factor or less over the entire 80:1 speed range resulting in smooth, quiet, cool and low maintenance motor operation.

Potentiometer Kit 202-0066 is included with a purchase of the PCMXP10-115AC

Let's Talk About Your Project


Contact the factory for volume pricing

Enclosure Maximum
Power Range
SCR Rated (PWM Rated)
Field / Shunt
Braking Reversing Isolation


Chassis 10* 115 0 - 130 1/4 - 1 (1 1/2) .19 - .75 (1.1) No No No 0-10 VDC

* Heat sink kit 223-0159 must be used when the continuous output current is above 5 amps.


  • MM Footprint: Traditional MM mounting pattern and footprint
  • Isolated Logic: Allows floating or grounded 0 - 10 VDC signal
  • Accepts AC or DC Input: Can accept 100-160 VDC or 70-130 VAC input
  • Low Cost: Designed for cost savings in large quantities for OEMs

Technical Data

  • 1.05 Form Factor
  • 1% Base Speed Regulation
  • 80:1 Speed Range

Trim Pots

  • Maximum Speed
  • Minimum Speed
  • Signal Adjust
  • Current Limit
  • IR Compensation