click here to chat with us

MM03-230AC-PCM DC Motor Control

MM-PCM Series

Similar to our MM23000C series in length and width, the ''piggyback'' design allows for many features in a small package.

The MM03-230AC-PCM series drive accepts non-isolated voltage (0-10VDC) or current (4-20mA) signals coming from an in-plant process, programmable logic controller, motion controller, etc. to control speed. A quick connect removable terminal block allows users to quickly detach the drive without disconnecting the wires from the terminal block. Also included is an optically isolated normally-closed stop and normally-open start input. This allows remote starting and stopping of the motor with switches or pushbuttons.

Potentiometer Kit 202-0079 is included with a purchase of the MM03-230AC-PCM


Contact the factory for volume pricing

Enclosure Maximum
Power Range Field / Shunt
Braking Reversing Isolation
MM03-230AC-PCM Chassis 3 230 0 - 90 1/50 - 1/4 .01 - .19 100 / 200 No No 0 - 10 VDC
4 - 20 mA
0 - 180 1/25 - 1/2 .03 - .37


  • ACE Footprint: Traditional ACE mounting pattern and footprint
  • Isolated Logic: Allows floating or grounded 0 - 10 VDC signal
  • Field Supply: Voltage output to energize the field winding of a shunt-wound motor
  • Stopping Modes: Inhibit (N.O. or N.C.) for coasting to a stop. Can be used for frequent starting and stopping
  • Diagnostic LEDs: Current Limit, Inhibit, Power, Run
  • On-board Fuses: Drive includes on-board fuses

Technical Data

  • 1.37 Form Factor
  • 2% Base Speed Regulation
  • 60:1 Speed Range

Trim Pots

  • Maximum Speed
  • Minimum Speed
  • Acceleration
  • Deceleration
  • Current Limit
  • IR Compensation
Introduction to the MM-PCM Series
MM-PCM Series Potentiometer Wiring
MM-PCM Series Signal Input Wiring